Whole interval recording

Whole interval recording is an interval method where you score an interval only if the behavior happens for the entire interval. If the behavior stops even briefly, the interval is not scored. It tends to underestimate how much behavior occurred.

What is whole interval recording?

In whole interval recording, you divide the observation into equal intervals and mark an interval only when the behavior continues from the first second to the last. You report the percentage of intervals scored. Because any gap prevents a mark, the result usually falls below the true amount of behavior.

How does it look in a session?

Suppose you use 15-second intervals for on-task behavior. A learner who works for 12 seconds and glances away does not earn the interval. A learner who works for all 15 seconds does. After 40 intervals, you divide the marked intervals by 40 to report the percentage of the session the learner was fully on task.

Example: Ethan stays seated for the full interval 18 times out of 30. You report 60 percent of intervals, even though he was seated for much of the other 12 as well.

Why does whole interval underestimate behavior?

A behavior that fills 90 percent of an interval still goes unscored. That makes the percentage lower than the real time spent on the behavior. Because of this bias, teams often choose whole interval when they want to increase a behavior, since a rise in the score reflects real, sustained gains.

  • Behavior that stops for a moment is not scored
  • Good for behaviors the team wants more of, such as staying on task
  • A learner's independent play may look lower than it really is

When is whole interval recording chosen?

It is chosen for behaviors that tend to be continuous and that the team wants to increase, such as engagement or appropriate play. It also helps when counting instances is hard. The supervisor picks the interval length, and you use that exact length each session to keep the data consistent.

How is whole interval different from partial interval and MTS?

Whole interval needs the behavior for the entire interval, partial needs it for any part of the interval, and momentary time sampling checks only the exact moment each interval ends. Whole underestimates, partial overestimates, and momentary time sampling gives a fairly neutral estimate, though it can miss behavior between checks.

Exam trap: a question may say the technician uses whole interval recording and independent play usually lasts most of an interval. The best answer points out the data will be lower than the real amount.

Practice questions

Question 1 · Data collection and graphing

A technician divides a work period into 15-second intervals. She marks an interval only if Ethan stays on task for the entire interval. Which method is she using?

Question 2 · Data collection and graphing

A technician uses whole interval recording for Darius's independent play. He often plays for most of an interval but stops briefly near the end. How are these data most likely to compare with his actual play time?

Question 3 · Data collection and graphing

Using partial interval recording, a technician observes 40 intervals and scores off-task behavior in 14 of them. What percentage of intervals should she report?

Questions people ask

Is whole interval recording continuous measurement?

No. It samples the session in intervals, so it is discontinuous and gives an estimate.

Which dimension does it describe?

It estimates how much of the session the behavior filled, closer to duration than to frequency.

How ready are you?

Ten questions, about 3 minutes, no account. Get your readiness score and your weakest domains.

Check my readiness