Momentary time sampling
Momentary time sampling, or MTS, is a method where you check whether the behavior is happening at the exact moment each interval ends, and ignore what happened in between. You report the percentage of checks where the behavior was occurring.
What is momentary time sampling?
Momentary time sampling records whether the behavior is occurring at the instant a timer signals the end of each interval. You score a plus if the learner is doing the behavior at that exact moment and a minus if not. The percentage of plus marks estimates how much of the session the behavior filled.
How does it work in a session?
Set a vibrating timer, perhaps every two minutes. When it goes off, look at the learner and note whether the behavior is happening right then. Whatever occurred before that moment does not matter. After 20 checks with the behavior present for 8, the result is 40 percent of moments.
Example: at a day program, a timer buzzes every 2 minutes and the technician glances at Grace. Grace is working at 7 of the 15 checks, so on-task behavior is 47 percent of sampled moments.
Because you only look at a single instant, you can keep teaching or supporting the group between checks.
What are the strengths of MTS?
MTS asks little of the observer. You only need to attend at set moments, so it fits busy classrooms or settings with several learners. It does not systematically overestimate or underestimate behavior the way partial and whole interval do, and it works well for behaviors that last a while.
- Less demanding than watching continuously
- Easier for one person to run with multiple learners
- Better for ongoing behaviors than for short, rare ones
What are its limits?
MTS can miss behavior that occurs between checks, so brief or infrequent behaviors may look like zero. If a learner has a short outburst a few seconds after each check, it will never be scored. For this reason it is a poor choice for behaviors that are brief or rare.
How is MTS different from partial interval recording?
Partial interval scores an interval if the behavior occurs at any point in it, so you watch the whole time. MTS scores only what is happening at the end of the interval, so you watch for one instant. That makes MTS less work but less sensitive, while partial interval is more sensitive and tends to overestimate.
Exam trap: scoring MTS by what happened earlier in the interval. If the learner was flapping for most of a minute but stopped just before the signal, you mark a minus.
Practice questions
At a day program, a vibrating timer goes off every 2 minutes. Each time, the technician glances at Grace and records whether she is engaged with her craft at that moment. Which method is this?
Using momentary time sampling, a technician checks Owen 20 times during a session. He is rocking at 5 of the checks. What percentage of intervals should be recorded?
Using 1-minute momentary time sampling, a technician sees Bella flapping her hands for nearly the whole minute, but she stops one second before the timer signals. How should that interval be recorded?
Questions people ask
Is MTS good for aggression?
Usually not. Brief or rare behaviors are easy to miss between checks, so teams use other methods.
What does MTS report?
A percentage of moments, or sampled checks, in which the behavior was happening.
How ready are you?
Ten questions, about 3 minutes, no account. Get your readiness score and your weakest domains.
Check my readiness