Interresponse time

Interresponse time, or IRT, is the amount of time between the end of one response and the start of the next response of the same kind. If a learner finishes one math problem at 1:00 and starts the next at 1:05, the IRT is five seconds. It describes the spacing of behavior.

What is interresponse time?

Interresponse time is the gap between two consecutive instances of the same behavior, from the end of the first to the start of the second. It captures pacing. Short IRTs mean responses are bunched together, and long IRTs mean they are spread out, which is useful when the goal is to slow behavior down or speed it up.

How do you time IRT in a session?

Start the stopwatch the moment one response ends, and stop it the moment the next response begins. Record the seconds or minutes, then restart at the end of that response. You need at least two instances to get one IRT. Averaging several gaps gives a picture of typical spacing.

Example: Kira finishes a worksheet item and you start the timer. She begins the next item after 12 seconds, so the IRT is 12 seconds. You restart the timer when that item ends.

When is IRT useful?

IRT helps when the team cares about pacing rather than the total count. A plan might aim to lengthen the pause between bites so a learner eats at a safer speed, or to shorten the pause between steps of a routine. It is related to rate, since longer IRTs mean lower rates.

  • Slowing the pace of eating or drinking
  • Reducing long delays between steps of a task
  • Spacing out requests for attention

How is IRT different from latency?

Latency begins on a cue, such as an instruction, and ends when the response starts. IRT begins when a response ends and runs until the next response starts, with no cue needed. Both measure waiting, but IRT is the wait between two responses while latency is the wait between a cue and one response.

A memory hook: latency has a cue at the start. IRT has a response at the start.

What exam traps involve IRT?

Scenarios often describe timing between two actions, and the tempting answer is latency. If no instruction or cue starts the clock, it is IRT. A second trap is starting the clock at the beginning of the first response, which would add that response's duration to the gap.

  • Calling IRT latency when no cue is present
  • Starting the clock at the start of the first response
  • Forgetting IRT needs two responses to exist

Practice questions

Question 1 · Data collection and graphing

A technician times the seconds between Kira finishing one worksheet item and starting the next. A coworker says this is latency. Why is the coworker incorrect?

Question 2 · Data collection and graphing

The plan says to record latency to compliance with "Clean up the blocks." The technician starts her timer when Ava begins picking up blocks and stops it when the last block is in the bin. What did she actually record?

Question 3 · Data collection and graphing

During a 60-minute session, Jonah has three crying episodes lasting 2, 5 and 8 minutes. The plan asks for total duration per session. What should the technician record?

Questions people ask

Is IRT the same as rate?

No, but they are related. Longer gaps between responses produce a lower rate, though rate is a count per time and IRT is the time between individual responses.

Would an RBT choose to measure IRT?

Your supervisor chooses the measurement system. You collect IRT as written and report if the timing points are unclear.

How ready are you?

Ten questions, about 3 minutes, no account. Get your readiness score and your weakest domains.

Check my readiness