Latency
Latency is the amount of time between a cue, such as an instruction, and the moment the learner begins responding. If you say put on your shoes and the learner starts four seconds later, the latency is four seconds. It measures how quickly behavior starts.
What is latency in ABA?
Latency is the elapsed time from a specific stimulus, usually an instruction or a bell, to the first moment the learner starts the response. The clock starts on the cue and stops at onset of the behavior, not at its end. It is useful when the goal is faster starting or a shorter delay.
How do you measure latency in a session?
Give the instruction, start a stopwatch as you finish speaking, and stop it the moment the learner begins responding. Write the number of seconds. You repeat across opportunities and often average them. Be consistent about what counts as starting, such as the first step toward the shoes.
Example: you say, Mateo, put on your shoes, and start the timer. Mateo reaches for the shoes at nine seconds, so the latency is nine seconds, even if finishing took another minute.
A written definition of onset keeps two observers from stopping the clock at different moments.
When is latency the right dimension?
Latency fits when the concern is delay. A learner who eventually follows instructions but takes a long time to start is a typical case. It also suits behaviors that should begin quickly, such as moving to the door when the bell rings, or any response where the cue is clear.
- Delay before starting a requested task
- Time to respond after a question
- Time to begin transitioning after a warning
How is latency different from duration and IRT?
Latency starts the clock on a cue and stops it when the response begins. Duration starts when the response begins and stops when it ends. Interresponse time measures the gap between the end of one response and the start of the next, with no cue involved. The starting event of the stopwatch tells them apart.
| Measure | Clock starts on | Clock stops on |
|---|---|---|
| Latency | A cue or instruction | Start of the response |
| Duration | Start of the response | End of the response |
| Interresponse time | End of one response | Start of the next response |
What exam traps involve latency?
The most common trap is a scenario that mentions timing, with answer choices for duration, latency, and IRT. Identify the cue first. If an instruction begins the stopwatch, it is latency. Another trap is stopping the clock when the task is finished rather than when it starts.
Practice questions
A technician says, "Mateo, put on your shoes," starts a stopwatch, and stops it the moment Mateo reaches for his shoes. What is she measuring?
The plan says to record latency to compliance with "Clean up the blocks." The technician starts her timer when Ava begins picking up blocks and stops it when the last block is in the bin. What did she actually record?
A technician times the seconds between Kira finishing one worksheet item and starting the next. A coworker says this is latency. Why is the coworker incorrect?
Questions people ask
Does latency measure how long the behavior lasts?
No. That is duration. Latency only covers the wait before the response starts.
Is a shorter latency always better?
It depends on the goal. For following instructions, shorter usually shows progress, but the plan from your supervisor defines what change is wanted.
How ready are you?
Ten questions, about 3 minutes, no account. Get your readiness score and your weakest domains.
Check my readiness